• 0Days
  • 0Hours
  • 0Minutes
  • 0Seconds

Observator 100 years

Redesign OMC-160 Cup & Vane Wind Sensor

Friday 19 January 2018

The popular OMC-160 Cup and Vane type anemometer is often used in nav-com packages for both new builds and retrofits. Due to its ruggedized design and non-contact measuring devices many marine, navy, offshore vessels and platforms are supplied with this sensor. Also, many airports, harbour and container terminals depend on wind measurement using the OMC-160.

The design of the internal electronics and measuring devices of the “old” OMC-160 are based on electronics from the 90’s and therefore are becoming increasingly difficult to source, which has resulted in higher production costs. This increased cost had forced us to decide to either raise the list price of the sensor or to go for a redesign.

Redesign of the OMC-160

This news-item shows that we have chosen to go for a redesign. We have selected the principle of non-contact position sensors for both wind speed and wind direction. This has resulted in a same accuracy for wind speed and an even higher accuracy for wind direction, compared to the previous version.

Using this new principle it was also possible to devise an easier way to line up the sensor to North. The only thing which has disappeared in the redesign is the ‘old’ TTY output which could be selected on the previous version. The OMC-160-3 is provided with the latest specification NMEA output with selectable baud rate.

« back to news

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close